1. Though independent service To/in is not recommended, it is possible to take some preventive measures for extension of its working capacity.
2. Once a month include To/in to be convinced of greasing of internal components and integrity of consolidations.
3. Watch system of cooling and composition of cooling liquid to avoid radiator freezing at work К/В.
4. Keep clean and integrity the To/in condenser to avoid violation of heat exchange and decrease in efficiency К/В.
5. For collecting and condensate plum at the bottom of the evaporator is provided a drainage tube. Do not allow its contamination to avoid work violation To/in and condensate pourings on a salon floor.
6. For check To/in carry out the following procedures.
7. Regularly examine К/В system components. Be convinced of absence of leakages of a coolant, damages of the coupling of the compressor, serviceability of a drive of the compressor, purity of a drainage tube of the evaporator and honeycombs of condenser, integrity of conducting and its isolation, sockets and safety locks.
8. The leakage of a coolant is shown in the form of deposits in a place of leak which acquire over time oily dirt.
9. Make sure that the motor of the fan works in all modes. Check an air stream via deflectors.
|
|
Remember that at high humidity efficiency even completely serviceable To/in falls, since the thermal capacity of damp air is much less, than dry. |
|
|
