Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
+ Brake system
- Suspension bracket and steering
Specifications
Removal and installation of forward shock-absorbers
Removal and installation of the forward stabilizer of cross-section stability
Removal and installation of assembly of a rotary fist with a nave
Check of a condition and replacement of spherical support
Removal and installation of torsionny bars
Removal and installation of the top managing director of the lever of a forward suspension bracket
Removal and installation of the bottom managing director of the lever of a forward suspension bracket
Removal and installation of back shock-absorbers
Removal and installation of a bar of the back stabilizer of cross-section stability
Removal and installation of a jet bar
Removal and installation of a screw spring of a back suspension bracket
Removal and installation of levers of a back suspension bracket
Removal and installation of a steering wheel
Condition check, removal and installation of drafts of a steering drive
Replacement of protective covers of assembly of the steering mechanism
Removal and installation of the steering mechanism
Removal and installation of the steering pump
Air removal from a hydraulic path of system of strengthening of a wheel
Wheels and tires - the general information
Corners of installation of wheels
+ Body
+ Onboard electric equipment
|
Removal and installation of the top managing director of the lever of a forward suspension bracket
Details of installation of the top lever of a suspension bracket
|
|
1. Details of installation of the top lever of a suspension bracket are presented on an illustration above.
2. Cock the parking brake. Weaken nuts of fastening of the corresponding forward wheel. To Poddomkratta a car front also establish it on props. Remove a wheel and its loker.
3. Remove a support of the brake mechanism and tie up it aside to a suspension bracket element (see. Head Brake system).
4. Remove from the top lever of a suspension bracket basic arms of a brake hose and, on models from ABS, from electroconducting of the wheel sensor.
5. Prop up the bottom lever of a suspension bracket a telezhechny jack.
|
|
The lever should remain propped up during all time of performance of procedure. |
6. Remove a torsionny bar (see. Section Removal and installation of torsionny bars).
7. Disconnect from the top lever of a suspension bracket a rotary fist (see. The section Removal and installation of assembly of a rotary fist with a nave).
|
|
8. Note the provision of cams of adjustment of disorder on a body, give nuts and remove cams (address to an accompanying illustration). |
9. Remove the top lever of a suspension bracket.
10. Estimate a condition and degree of wear of plugs. Defective components replace, replacement should be made in the conditions of a car-care center workshop.
11. Installation is made upside-down. Track, that all fixture was tightened with demanded effort. It will be reasonable to make check and adjustment of corners of installation of forward wheels. |
|
|
|