|
Removal and installation of a jet bar
Components of fastening of a jet bar
|
|
1. Prop up forward wheels protivootkatny boots. To Poddomkratta a car back also establish it on props.
2. Prop up assembly of the back bridge by a telezhechny jack.
3. Disconnect from assembly of the back bridge the LSP & BP valve (see. Head Brake system).
4. Disconnect the top end of a jet bar from the basic arm on a bearing frame of the car (address to an illustration above).
5. Disconnect the bottom end of a bar from a basic arm on assembly of the back bridge.
6. Remove a jet bar.
7. Installation is made upside-down. Track, that all fixture was tightened with demanded effort. The tightening of fixture is carried out after car lowering on the earth. |
|
|
