Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation

Removal and installation of the steering pump

Pump GUR arrangement

Components of assembly of the pump GUR

PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Remove air purifier assembly (see. Head of the Power supply system and production of the fulfilled gases).
3. Remove a driving belt (see. Head of Control and routine maintenance of the car).
4. Get under assembly of the steering pump drain capacity. Disconnect from a back part of the pump pressure head and returnable lines of a hydraulic path (address to an illustration a pump GUR Arrangement). At once закупорьте the open ends of lines in order to avoid hit in dirt system.
5. If the pump is subject to replacement, remove from it a driving pulley.

Dismantle of a pulley can be made on a workbench after removal of the pump from the car.

6. Give fixture and take assembly of the steering pump from an impellent compartment, try not to allow a spillage of hydraulic liquid on the painted body surfaces.
7. Components of assembly of GUR are presented on an illustration Components of assembly of the pump GUR.
8. Installation is made upside-down. Track, that the corresponding fixture was tightened with demanded effort.
9. Fill in in the tank of the steering pump demanded amount of hydraulic liquid of the corresponding grade (see. Head of Control and routine maintenance of the car), then pump over system of hydrostrengthening of a wheel (see. The section air Removal from a hydraulic path of system of strengthening of a wheel).