Removal and installation of a bar of the back stabilizer of cross-section stability
Components of installation of the back stabilizer of cross-section stability
|
1. Components of installation of the stabilizer of cross-section stability are presented on an illustration above. 2. Prop up forward wheels protivootkatny boots. To Poddomkratta a car back also establish it on props.
|
3. Give fixing bolts and nuts and remove both racks of the stabilizer (address to an accompanying illustration). |
|
4. Turn out bolts of arms of fastening of a bar (address to an accompanying illustration). |
5. Remove a bar of the stabilizer of cross-section stability from the car. 6. Estimate a condition of rubber plugs, defective components replace. 7. Installation is made upside-down. Track, that all fixture was tightened with demanded effort. |
|
|