1. To Poddomkratta the car also establish it on props. At the corresponding complete set remove protection of a case.
2. Give nuts (address to an illustration above) and take bolts of fastening of racks of the stabilizer of cross-section stability.
3. Give bolts/nut of collars of fastening of a bar of the stabilizer of cross-section stability to a car frame.
4. Take a bar of the stabilizer of cross-section stability from under the car and remove from it rubber plugs.
5. Estimate a condition of plugs, in case of need make their replacement.
6. At installation of new plugs, track, that they appeared are developed by cuts forward on the car.
7. Installation is made upside-down. Track, that all fixture was tightened with demanded effort (address to an illustration above). |
|