|
Removal and installation of levers of a back suspension bracket
Components of installation of levers of a back suspension bracket
|
|
1. Components of installation of the stabilizer of cross-section stability are presented on an illustration above.
2. Prop up forward wheels protivootkatny boots. To Poddomkratta a car back also establish it on props.
3. Prop up the back bridge a telezhechny jack.
4. On the equipped ABS models liberate electroconducting of the wheel sensor from basic arms on assembly of the top levers.
|
|
5. Give nuts, throw off washers and take bolts of fastening of the top levers of a suspension bracket to a frame and assembly of the back bridge (address to an accompanying illustration). |
|
|
6. Give nuts, throw off washers and take bolts of fastening of the bottom levers of a suspension bracket to a frame and assembly of the back bridge (address to an accompanying illustration). |
7. Estimate a condition of rubber plugs of the lever. Make replacement of defective plugs in the conditions of a car-care center workshop.
8. Installation is made upside-down. Track, that all fixture was tightened with demanded effort. A tightening fixture make after car lowering on the earth. |
|
|