Removal and installation of assembly of a rotary fist with a nave
Remember that developed in the course of operation of brake mechanisms the dust can contain extremely unhealthy the person asbestos. At all do not blow off a dust the compressed air and do not inhale it, at service of mechanisms put on a protective mask or a respirator. Do not use for rubbing of components of brake system gasoline or solvents on an oil basis, apply only firm cleaners or methyl alcohol!
Nave of a forward suspension bracket
PERFORMANCE ORDER
1. Cock the parking brake. Weaken nuts of fastening of the corresponding forward wheel, поддомкратьте a front of the car and establish it on props. Remove a wheel. 2. Disconnect from a rotary fist a basic arm of a brake hose and the other lines of communication provided by a complete set (address to an illustration above). On the equipped ABS models remove from fist assembly the wheel sensor (see. Head Brake system). 3. Remove nave assembly with a brake disk (see. Head Transmission line). 5. Remove a bryzgootboynik of a brake disk (see. Head Brake system). 6. Remove an epiploon, laying and a boot (address to an illustration above). 7. Disconnect from a rotary fist a tip of steering draft (see. Section condition Check, removal and installation of drafts of a steering drive). 8. To Poddomkratta the bottom lever of a suspension bracket also disconnect it from a rotary fist. 9. Remove шплинт and give a nut. 10. Disconnect a rotary fist from the top lever. 11. Remove a rotary fist from the bottom lever. 12. Installation is made upside-down. Track, that all fixture was tightened with demanded effort.