|
Check of serviceability of functioning and replacement of the breaker of indexes of turns / alarm system and switch of the last
|
|
Models of cars considered in the real Management are equipped with system of additional safety (SRS). Before starting performance of any works near the block of a safety cushion, a steering column or the dashboard, disconnect SRS in order to avoid receiving traumas at its casual operation (see. The Safety cushion section - the general information). Electroconducting of a chain of SRS is easy for distinguishing on yellow color of isolation.
|
|
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!
|
Check
Location of the breaker of indexes of turns / alarm system
The breaker of indexes of turns / the alarm system is fixed under the left bottom section of furnish of the dashboard (address to an illustration above).
Serviceability of functioning of the breaker proves to be true distinctly heard rhythmical clicking. At refusal of one of indexes frequency of operation of the breaker doubles, informing the driver on need of performance of replacement failed lamps/lamps.
|
|
| Simultaneous refusal of both indexes with high degree of probability testifies to failure of the corresponding safety lock in the internal assembly block. Refusal possibility actually the breaker, or the podrulevy switch is not excluded also. Check a condition of contact connections of electroconducting of the corresponding chain. At knocking-out of a safety lock check electroconducting on existence of signs of short circuit, be verified with schemes of electric connections (see. The section of the Scheme of electric connections - the general information). |
|
Replacement
Breaker
|
|
1. Remove the left bottom section of furnish of the dashboard (see. Head the Body) also disconnect from breaker assembly electroconducting and take the breaker.
2. Track, that the replaceable breaker on the standard size corresponded failed.
3. Installation is made upside-down. |
|
Switch of the alarm system
|
|
| Having hooked, liberate switch assembly from the dashboard, disconnect from the switch electroconducting. |
|
|