Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
Search of causes of failures of electric equipment
Safety locks - the general information
Fusible inserts - the general information
Chain breakers - the general information
The relay - the general information and check of serviceability of functioning
Digital tire of data of CAN
Check of serviceability of functioning and replacement of the breaker of indexes of turns / alarm system and switch of the last
Replacement of the switch of indexes of the turn/switch of modes of functioning of external lighting devices
Replacement of the switch of ignition and lock of blocking of a steering column
Check of serviceability of functioning and replacement of the switch of modes of functioning of cleaners of a windscreen
Replacement of lamps of head headlights
Adjustment of the direction of optical axes of head headlights
Removal and installation of block headlights
Replacement of lamps
Removal and installation of an audiosystem and its loudspeakers
Removal and installation of the aerial of a radio receiver
Check of serviceability of functioning, replacement of the electromotor of a drive of screen wipers and pump of washers
Check of serviceability of functioning and replacement of the switch of heating of back glass
Check of serviceability of functioning and regenerative repair of a heater of back glass
Removal and installation of a combination of devices
Check of serviceability of functioning and replacement of horns of a horn
The electric drive of external rear-view mirrors - general information and check of serviceability of functioning
Control system of speed (темпостат) - general information, check of serviceability of functioning of components
The electric drive of window regulators - general information and check of serviceability of functioning
The uniform lock and system of remote control by door activators - general information and check of serviceability of functioning
Running fires of light time of day (DRL)
Safety cushions - the general information
+ Schemes of electric connections - the general information
|
Removal and installation of an audiosystem and its loudspeakers
Radio receiver
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action! |
2. Remove the central panel of facing of a combination of devices (see. Head Body).
|
|
3a. Turn out fixing bolts (address to an accompanying illustration). |
|
|
3b. Liberate radio receiver assembly from the landing nest in the panel of prior (address to an accompanying illustration). |
|
|
3с. Disconnect from radio receiver assembly an antenna cable and electroconducting (address to an accompanying illustration). |
4. Finally take radio receiver assembly.
5. Installation is made upside-down. |
|
Loudspeakers Each of doors is equipped at least with one loudspeaker. Also door VCh of dynamics usually enter into a complete set. Also back loudspeakers and the loudspeaker can enter into an additional complete set and established on the dashboard.
|
|
|
|
1a. Remove the panel of an internal upholstery of the corresponding door of the car (see. Head Body). Turn out fixing screws (address to an accompanying illustration). |
|
|
1b. Disconnect electroconducting and remove a loudspeaker subject to replacement (address to an accompanying illustration). |
2. For removal of a back loudspeaker or the loudspeaker established in the dashboard, remove the corresponding panel of facing, disconnect electroconducting and turn out fixing screws.
3. Installation is made upside-down. |
|
|
|
