Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation



Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Search of causes of failures of electric equipment
   Safety locks - the general information
   Fusible inserts - the general information
   Chain breakers - the general information
   The relay - the general information and check of serviceability of functioning
   Digital tire of data of CAN
   Check of serviceability of functioning and replacement of the breaker of indexes of turns / alarm system and switch of the last
   Replacement of the switch of indexes of the turn/switch of modes of functioning of external lighting devices
   Replacement of the switch of ignition and lock of blocking of a steering column
   Check of serviceability of functioning and replacement of the switch of modes of functioning of cleaners of a windscreen
   Replacement of lamps of head headlights
   Adjustment of the direction of optical axes of head headlights
   Removal and installation of block headlights
   Replacement of lamps
   Removal and installation of an audiosystem and its loudspeakers
   Removal and installation of the aerial of a radio receiver
   Check of serviceability of functioning, replacement of the electromotor of a drive of screen wipers and pump of washers
   Check of serviceability of functioning and replacement of the switch of heating of back glass
   Check of serviceability of functioning and regenerative repair of a heater of back glass
   Removal and installation of a combination of devices
   Check of serviceability of functioning and replacement of horns of a horn
   The electric drive of external rear-view mirrors - general information and check of serviceability of functioning
   Control system of speed (темпостат) - general information, check of serviceability of functioning of components
   The electric drive of window regulators - general information and check of serviceability of functioning
   The uniform lock and system of remote control by door activators - general information and check of serviceability of functioning
   Running fires of light time of day (DRL)
   Safety cushions - the general information
   + Schemes of electric connections - the general information


Immerse yourself in captivating storylines and compelling characters on 123movies.


Removal and installation of the aerial of a radio receiver

Below the description of procedure of dismantle of the aerial of external type is provided. Some models are equipped with the aerial pasted on a windscreen, service of such aerials lies outside the limits of qualification of the average amateur mechanic and it should be entrusted to specialists of car-care center.


 PERFORMANCE ORDER

Remove a radio receiver and disconnect from it an antenna cable (see. Section Removal and installation of an audiosystem and its loudspeakers). "Walk" on an antenna cable, liberating it from intermediate clamps. Tie up by the cable end a string piece. The route of laying of a cable of the aerial is presented on an accompanying illustration.

The aerial with the fixed mast

 PERFORMANCE ORDER

1. By means of a small rozhkovy key of the suitable size turn out an aerial mast from the basis.
2. Give a nut of fastening of assembly of the basis of an antenna mast (address to an accompanying illustration), use flat-nose pliers for removal of lock rings. Having pulled, take outside an antenna cable (leave the string tied up to a cable passed in an opening under mast installation. Carefully remove all traces of dirt and a rust from a place крепленияантенны.
3. Tie up to a string a cable of the new aerial and involve it in a body element.
4. Further installation is made as it should be the return to an order of dismantle of components.

The aerial with an electrodriving mast

For performance of this procedure the help of the assistant is required.


The system contains the relay. If the drive of the aerial ceased to function, first of all, check the relay. Э / the drive motor seldom fails.


 PERFORMANCE ORDER

1. If disconnected, connect the storage battery and turn the ignition key in the situation LOCK.
2. Give a nut of fastening of the basis of an antenna mast (address to an illustration above).
3. Further one person should be in salon of the car, the second – to hold an antenna mast. Ask the assistant to press at the same time the AM/FM button on control panels of a radio receiver and to turn the ignition key in situation ASS, the antenna mast should be put forward on all length of the course then it can be disconnected from the driving electromotor. Remove a mast, the ignition key leave in situation ASS.
4a. Remove a loker of protection of a wheel arch of the corresponding wing of the car (see. Head the Body) and отболтите from a wing the electromotor of a drive of an antenna mast. Completely extend an antenna cable outside, having left the string tied up to it passed in an opening in a body element (address to an accompanying illustration).
4b. Release three clamps and remove the panel of facing of a wheel arch, then give a fixing bolt and remove the driving electromotor (address to an accompanying illustration).
4с. Polarity of plugs the socket of the electromotor of a drive of the aerial look on an accompanying illustration.
5. Tie up to the left string passed through the body panel a cable of the new aerial and involve it back in car salon.
6. Establish on the regular place the electromotor of a drive of an antenna mast.
7. Establish an antenna mast, having developed a cable the gear party forward on the car.
8. Turn the ignition key in the situation LOCK, the cable should be winded, and the mast to be involved in a wing.

If the key for any reason was earlier transferred from situation ASS to the situation LOCK, repeat the procedure described in paragraph 8. If at key turn in the situation LOCK the cable does not start to be taken up, stir it on an entrance in the mechanism that the bottom end was developed and it was grasped by the coil.

9. Screw a nut of fastening of the basis of an antenna mast even if the last was not up to the end involved yet in the wing panel. The mast should be involved finally at a nazhimaniye on any of buttons of a choice of a radio range on the control panel by a radio receiver.
10. Further installation is made as it should be the return to an order of dismantle of components.