Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
- Engine
+ Typical procedures of service of engines
- Procedures of service of the petrol engine
Removal and installation of covers of heads of cylinders
Removal and installation of the inlet pipeline
Removal and installation of final collectors
Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM
Replacement of a forward epiploon (ов) cranked shaft / camshafts
Replacement of a back epiploon of a cranked shaft
Removal and installation of camshafts and pushers of valves
Removal and installation of heads of cylinders
Removal and installation of the pallet of a case of the engine
Removal, check of a condition and installation of the oil pump
Removal and installation of a driving disk
Check of a condition and replacement of support of an engine mount
+ Procedures of service of the diesel engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Replacement of a back epiploon of a cranked shaft
|
|
1. Remove a transmission (see. Head gear shifting Box).
2. Remove a driving disk.
|
|
3. Removal of an old epiploon can be made without preliminary dismantle of the holder by a poddevaniye way by its screw-driver (address to an accompanying illustration), however, in order to avoid risk of damage of a pin of a cranked shaft, originators of the real Management recommend to operate according to the instructions stated below. |
4. Turn out bolts of fastening of the holder to the block and remove assembly, smooth out interfaced surfaces from fragments of a material of laying and old hermetic.
|
|
Stop up an open part of the pallet with rags in order to avoid hit in small garbage. |
|
|
5. Having laid the removed holder on a workbench on two wooden blocks, beat out an old epiploon a drift from the back party of a plate (address to an accompanying illustration). |
|
|
6. Wipe a nest under epiploon landing by acetone. Lay the holder on a flat firm surface and begin to knock in a nest a new epiploon, as an opravka having used wooden whetstone or a piece of a pipe of suitable diameter. The Toyota company recommends to use for installation of an epiploon of cylindrical opravky (SST 092233-15030-70010) of the suitable size (address to an accompanying illustration). |
7. Grease epiploon sponges with pure impellent oil.
|
|
8. Having accurately pressed the holder, plant it on the regular place. Act without hurrying up, watching that there was no wraparound of sponges of an epiploon at its putting on on a shaft pin (address to an accompanying illustration). Screw fixing bolts and evenly tighten them with demanded effort. |
9. Further installation is made as it should be, the return to an order of dismantle of components. |
|
|
|