Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation



Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
- Engine
   + Typical procedures of service of engines
   - Procedures of service of the petrol engine
      Removal and installation of covers of heads of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of final collectors
      Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM
      Replacement of a forward epiploon (ов) cranked shaft / camshafts
      Replacement of a back epiploon of a cranked shaft
      Removal and installation of camshafts and pushers of valves
      Removal and installation of heads of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation of a driving disk
      Check of a condition and replacement of support of an engine mount
   + Procedures of service of the diesel engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Check of a condition and replacement of support of an engine mount

Support of a suspension bracket of the power unit extremely seldom need the attention, however the damaged pillows should be replaced without any delay in order to avoid increase of loadings and premature wear of components of the transmission line.

Check

 PERFORMANCE ORDER

1. For check it is necessary to raise slightly the engine, having unloaded support.
2. To Poddomkratta the car also establish it on props. Get a jack under the pallet of a case of the engine (for the purpose of distribution of loading lay between a head of a jack and the pallet wooden whetstone). Cock a jack, having slightly raised the unit and having unloaded support.

At all do not perform any works under the car, withheld in the lifted situation by means of only one jack!

3. Check pillows of support (address to an accompanying illustration) on existence of cracks, signs of hardening of rubber and an otsloyeniye from the metal basis. Sometimes pillows start to break directly in the middle.
4. Estimate size люфта between plates of support and power a car unit/frame (as the lever use mount or a big screw-driver). In case of identification люфта lower the unit and tighten fixture of support.
5. Pillows, in order to avoid rubber destruction, should be processed by special protective structure.

Replacement

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

Cock the parking brake, поддомкратьте a front of the car and establish it on props. Prop up the engine (see paragraph 2, Check).
2. Release fixture to subject replacement of a support, raise the engine and remove a pillow.
3. Installation is made upside-down.

Before installation it is necessary to grease a carving part of fixture of support with fixing hermetic. Track reliability of a tightening of fixture.

4. The description of procedures of replacement of support of a suspension bracket of transmission is provided in Head a gear shifting Box.