Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation



Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
- Engine
   + Typical procedures of service of engines
   - Procedures of service of the petrol engine
      Removal and installation of covers of heads of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of final collectors
      Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM
      Replacement of a forward epiploon (ов) cranked shaft / camshafts
      Replacement of a back epiploon of a cranked shaft
      Removal and installation of camshafts and pushers of valves
      Removal and installation of heads of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation of a driving disk
      Check of a condition and replacement of support of an engine mount
   + Procedures of service of the diesel engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Replacement of a forward epiploon (ов) cranked shaft / camshafts

 PERFORMANCE ORDER

1. Remove a gas-distributing belt and a cogwheel (and) a cranked shaft/camshaft (ов) (see. Section Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM).

The forward epiploon of a cranked shaft is established in the oil pump which can be removed (see. The section Removal, check of a condition and installation of the oil pump) for simplification of replacement of an epiploon.

2. Measure depth of landing of an old epiploon. Accurately cut sponges of a forward epiploon of a cranked shaft with the sharp razor.
3. Having accurately hooked the special tool or a screw-driver, take an old epiploon from the landing nest (address to an accompanying illustration). Try not to leave scratches and задиров on a surface of a pin of a shaft or walls of a landing nest, existence of similar defects will lead to fast failure of a new epiploon.
4. Smooth out an internal surface of a landing nest. Slightly grease external edge of a new epiploon with pure impellent oil, in sponges of an epiploon fill universal greasing.
5. Having used as an opravka a face head of the corresponding size, or a piece of a pipe of suitable diameter, plant a new epiploon in the nest (address to an accompanying illustration) (the opravka should rest only against the firm external region of a face surface of an epiploon) on the same depth on which the old was drowned. Make sure of correctness of landing of an epiploon.
6. Establish into place a cogwheel (and) a cranked shaft/camshaft (ов) and a gas-distributing belt (see. Section Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM). Try not to damage responsible CMP sensor functioning a cogwheel site.
7. Start the engine and check it on existence of signs of leakages of oil around epiploon landing (ов).