Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation

Removal, installation and adjustment of a door of a back

In view of relevancy of weight of assembly of a door of a back it will be reasonable to secure with the help of the assistant.

Design of a door of a back


1 — a window regulator Regulator 2 — Right directing a window regulator 3 — a door Emphasis 4 — Back glass 5 — Left directing a window regulator 6 — the door Lock 7 — the Directing tape of facing of a window aperture 8 — the External sealing tape	9 — the Cover of a service opening 10 — the Plate 11 — the Cranked lever of a drive of a latch 12 — the lock Cylinder 13 — the Internal sealing tape 14 — the Facing panel of registration plate 15 — the Panel of an upholstery of a door of a back

PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Open a door of a back and reliably fix it in the lifted situation. Remove a door emphasis (address to an illustration above).
3. Disconnect the electroconducting laid between a door of a back and a body of the car. For this purpose liberate the plug through passage and disunite contact sockets.

4. Lead round loopy levels a marker and turn out bolts of their fastening (address to an accompanying illustration). By means of the assistant remove assembly of a door of a back from the car.

5. Installation is made upside-down.

6a. For replacement of the lock it is necessary to remove the panel of an internal upholstery of a door, the cover of a service window directing a tape of facing of a window aperture, a facing, sealing tape, glass, a regulator of a window regulator and directing a trench (see. The section Removal and installation flew down also a regulator of a window regulator of a door of a back). Remove the cranked lever of a remote drive of a latch of the door lock (address to an accompanying illustration).

6b. Remove the driving mechanism. The facing panel of registration plate fastens to a door of a back of the car by means of a nut and five clamps, give a nut and, hooking the panel, release clamps. Give two fixing nuts and remove the cylinder of zamkovy assembly, having in case of need disconnected the corresponding electroconducting. Walk on an executive rod and disconnect it, also disconnect a cable of a drive of an otpuskaniye of the lock (address to an accompanying illustration).

6c. Turn out three fixing bolts (address to an accompanying illustration) and remove assembly of a latch of the lock of a door. Installation is made upside-down.

7a. Door shift in the longitudinal direction is made by an otpuskaniye of nuts of fastening of loopy levels to a car body (address to an accompanying illustration), further loops подстукиваются by a hammer in the relevant party.

7b. Adjustment of provision of a door in a body aperture (to the right-to the left, up-down) is made by weakening of fixture of loops on a doorframe. Serviceability of operation of a latch is reached at the expense of correction of position of its drummer (address to an accompanying illustration). Having finished adjustment, strongly tighten the corresponding fixture.