Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
- Brake system
Specifications
System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
Replacement of brake shoes
Removal and installation of supports of disk brake mechanisms
Condition check, removal and installation of a brake disk
Removal and installation of the main brake cylinder (GTTs)
Check of a condition and replacement of brake lines and hoses
Sensitive to loading / перепускной the valve (LSP & BP)
Adjustment of the parking brake
Replacement of cables of a drive of the parking brake
Check of serviceability of functioning / tightness, removal and installation of the amplifier of brakes
Pumping of brake system
Adjustment of a pedal of a foot brake
Check of serviceability of functioning and replacement of the sensor switch of stoplights
Sensors and ABS system activator
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Condition check, removal and installation of a brake disk
Condition check
|
|
1. Weaken nuts of fastening of wheels, cock the parking brake, поддомкратьте the car and establish it on props. Remove the corresponding wheel.
2. Remove a brake support (see. The section Removal and installation of supports of disk brake mechanisms) also tie up it aside a wire to a suspension bracket element, without disconnecting a brake hose, try, that the hose did not appear is tense or overwound.
3. Make visual check of a condition of both working surfaces of a disk. Easy defects can be eliminated by means of a fine-grained emery paper. For removal of furrows by depth a disk it is necessary to remove and subject more than 0.4 mm to a pro-point. Remember that survey of a disk should be made from its both parties!
|
|
4. If during braking pedal pulsations were noticed, it is necessary to estimate size of lateral palpation of a brake disk. Fix a tsiferblatny measuring instrument of plunzherny type (DTI) at distance about 12.7 mm from external edge of a disk (address to an accompanying illustration). Null the device and start to rotate a disk. The result of measurement should not fall outside the limits the admissible range stipulated in Specifications, otherwise it is necessary to give a disk to a pro-point.
|
|
Originators of the real Management recommend to make a pro-point of disks regardless of their condition for the purpose of removal from working any surfaces of defects. As a last resort it is possible to be limited to disk processing by a fine-grained emery paper. |
|
5. At a pro-point of a disk it is necessary to give particular attention to observance of requirements of Specifications to its minimum admissible thickness, on a face surface of a disk the corresponding marking is provided. Measurement of thickness of a disk is made in several points by means of a micrometer. |
|
Removal and installation
|
|