Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation



Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
- Brake system
   Specifications
   System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
   Replacement of brake shoes
   Removal and installation of supports of disk brake mechanisms
   Condition check, removal and installation of a brake disk
   Removal and installation of the main brake cylinder (GTTs)
   Check of a condition and replacement of brake lines and hoses
   Sensitive to loading / перепускной the valve (LSP & BP)
   Adjustment of the parking brake
   Replacement of cables of a drive of the parking brake
   Check of serviceability of functioning / tightness, removal and installation of the amplifier of brakes
   Pumping of brake system
   Adjustment of a pedal of a foot brake
   Check of serviceability of functioning and replacement of the sensor switch of stoplights
   Sensors and ABS system activator
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Replacement of cables of a drive of the parking brake

Components of assembly of the parking brake

1 — the Pin
2 — the Cranked lever of a drive of the parking brake
3 — the Clip
4 — Shplint
5 — the Spring
6 — the Cover of the cranked lever
7 — the Arm of the cranked lever
8 — the Cable of the parking brake
9 — the Internal cable of the parking brake
10 — the Intermediate lever
11 — the Adjusting washer
12 — the Lock ring

13 — the Back disk brake mechanism
14 — the Returnable spring
15 — the Forward block
16 — Raspornaya a plate
17 — the Back block
18 — the Clamping spring
19 — the Brake disk
20 — Laying
21 — the Regulator
22 — spring Saddles
23 — the Holder of a block


Components of assembly of the parking brake are shown on an illustration above.

 PERFORMANCE ORDER

1. Release the parking brake. Weaken nuts of fastening of back wheels. To Poddomkratta the car also establish it on props. Remove wheels.
2. For a vybiraniye of a weak point of a driving cable weaken an adjusting nut (see. Section Adjustment of the parking brake).
3. Disconnect a cable from the cranked lever of a drive of the parking brake.
4. Disconnect an internal cable from the intermediate lever.
5. Liberate all cables from intermediate clamps on a bridge frame/case.
6. Installation is made upside-down.
7. Having finished installation, make adjustment of a drive of the parking brake.
8. Clean props and lower the car on the earth.