Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation



Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
- Brake system
   Specifications
   System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
   Replacement of brake shoes
   Removal and installation of supports of disk brake mechanisms
   Condition check, removal and installation of a brake disk
   Removal and installation of the main brake cylinder (GTTs)
   Check of a condition and replacement of brake lines and hoses
   Sensitive to loading / перепускной the valve (LSP & BP)
   Adjustment of the parking brake
   Replacement of cables of a drive of the parking brake
   Check of serviceability of functioning / tightness, removal and installation of the amplifier of brakes
   Pumping of brake system
   Adjustment of a pedal of a foot brake
   Check of serviceability of functioning and replacement of the sensor switch of stoplights
   Sensors and ABS system activator
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Removal and installation of supports of disk brake mechanisms

Remember that developed in the course of operation of brake mechanisms the dust can contain extremely unhealthy the person asbestos. At all do not blow off a dust the compressed air and do not inhale it, at service of mechanisms put on a protective mask or a respirator. At all do not use for rubbing of components of brake system by gasoline or solvents on an oil basis, apply only firm cleaners or methyl alcohol!


Supports of both brake mechanisms of one axis should change at the same time. Remember that at firm car repair shops Toyotas always it is possible to order the restored assemblies of brake supports on an exchange basis.


Details of installation of brake supports are presented on illustrations of the Detail of installation of forward brake shoes and a support and the Detail of installation of back brake shoes and a support.

 PERFORMANCE ORDER

1. Weaken nuts of fastening of forward wheels. To Poddomkratta a car front also establish it on props. Cock a lay brake / prop up protivootkatny boots wheels standing on the earth. Remove wheels.
2. Pump out from the GTTs tank about 2/3 brake liquids, at an otzhimaniye of pistons level liquid can start to be forced out from the tank. Get drain capacity under assembly of the brake mechanism and process a surface of the last a special cleaner. Get drain capacity under assembly of the corresponding brake mechanism and carefully wash out a surface of the last a special cleaner.
3. Give a cap shtutserny nut and disconnect the brake line from a support (address to an accompanying illustration).
4. Turn out bolts of fastening of a support (address to an accompanying illustration). If the support does not manage to be removed from a brake disk, therefore, blocks cling for formed on limit of wear of a disk a fillet, remove blocks (see. Section Replacement of brake shoes).
5. If the removed support is subject to further use, carefully wash out it in special cleaning liquid, at all do not use for washing of components of the brake mechanism kerosene and other oil products! Attentively check a support condition, in case of need make its replacement.
6. Establish a support on the regular place and tighten with demanded effort fixing bolts.
7. Connect to a support a brake hose (do not forget to replace sealing washers). Strongly tighten a cap nut of shtutserny connection.
8. If disconnected a brake hose, pump over the corresponding brake contour (see. Section Pumping of brake system).
9. Establish to the place of a wheel, lower the car on the earth and tighten wheel nuts with demanded effort (see. Head of Control and routine maintenance of the car). Before starting operation of a vehicle make sure of serviceability of functioning of brake system.