Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
- Brake system
Specifications
System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
Replacement of brake shoes
Removal and installation of supports of disk brake mechanisms
Condition check, removal and installation of a brake disk
Removal and installation of the main brake cylinder (GTTs)
Check of a condition and replacement of brake lines and hoses
Sensitive to loading / перепускной the valve (LSP & BP)
Adjustment of the parking brake
Replacement of cables of a drive of the parking brake
Check of serviceability of functioning / tightness, removal and installation of the amplifier of brakes
Pumping of brake system
Adjustment of a pedal of a foot brake
Check of serviceability of functioning and replacement of the sensor switch of stoplights
Sensors and ABS system activator
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Check of serviceability of functioning and replacement of the sensor switch of stoplights
Check
|
|
1. The sensor switch of stoplights is fixed on a basic arm of a pedal of a foot brake (address to an illustration Adjusting height of a pedal of a foot brake in the released condition). For the purpose of ensuring access remove the furnish panel under a steering column (see. Head Body).
2. At completely released pedal the sensor switch is in the opened situation. Already weak squeezing of a pedal leads to short circuit of the sensor switch and operation of stoplights.
3. If serviceability of operation of stoplights is broken, first of all check a condition of the corresponding safety lock (see. Onboard electric equipment) and filaments of lamps.
4. If a safety lock and lamps as it should be, check food existence on the sensor switch.
5. If food giving on the sensor switch is broken, check on existence of signs of break electroconducting on a chain site between the assembly block of safety locks and the sensor switch. If a food moves regularly, close the sensor switch (squeeze out a pedal of a foot brake) and check it on existence of target tension.
6. If target tension on the sensor switch is absent, it is necessary to make assembly replacement, otherwise check an electroconducting condition on a chain site between the sensor switch and lamps of stoplights (see. Onboard electric equipment). |
|
Replacement
|
|
1. Remove the finishing panel established under a steering column (see. Head Body).
2. Disconnect from the sensor switch of stoplights electroconducting.
3. Give the bottom lock-nut of the sensor switch.
4. Remove the sensor switch from a basic arm.
5. Installation is made upside-down. Having finished, make sensor switch adjustment (see. Section Sensors and ABS system activator). |
|
|
|