Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation



Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
- Power supply system and production of the fulfilled gases
   Specifications
   Sbrasyvaniye of pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a condition and replacement of fuel lines and their shtutserny connections
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Removal and installation of the fuel pump
   Replacement of the sensor of fuel consumption
   Removal and installation of assembly of an air purifier
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of electronic injection
   Check of a condition and replacement of components of system of injection
   Release system - the general information
   Removal and installation of nozzles
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Replacement of the sensor of fuel consumption

See preventions at the beginning of pressure Sbrasyvaniye's Section in a power supply system.


 PERFORMANCE ORDER

1. Accurately take assembly of the fuel pump/sensor of fuel consumption from a fuel tank (see. The section Removal and installation of the fuel pump), try not to damage a float of the sensor and the mesh filter of a toplivozabornik.
2. Disconnect from assembly electroconducting.
3. Turn out the screw, an assembly bracket of the sensor and take the last from assembly of a basic arm.
4. Installation is made upside-down. Do not forget to replace sealing laying of a landing flange of assembly.