Toyota Land Cruiser, Amazon, LX470 Lexus + Identification numbers of the car + Governing bodies and receptions of safe operation of the car + Settings and routine maintenance of the car + Engine + Systems of cooling of the engine, salon and air conditioning heating - Power supply system and production of the fulfilled gases Specifications Sbrasyvaniye of pressure in a power supply system Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel Check of a condition and replacement of fuel lines and their shtutserny connections Removal and installation of a fuel tank Cleaning and repair of a fuel tank - general information Removal and installation of the fuel pump Replacement of the sensor of fuel consumption Removal and installation of assembly of an air purifier Removal, installation and adjustment of a cable of an accelerator System of electronic injection of fuel (EFI) - the general information Check of serviceability of functioning of system of electronic injection Check of a condition and replacement of components of system of injection Release system - the general information Removal and installation of nozzles + engine Electric equipment + Control systems of the engine and decrease in toxicity of the fulfilled gases + gear shifting Box + Transmission line + Brake system + Suspension bracket and steering + Body + Onboard electric equipment
|
Removal, installation and adjustment of a cable of an accelerator
|
Adjustment of a hummock of a drive темпостата is made in a similar manner. |
Removal
|
1. Disconnect a negative wire from the battery.
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action! |
|
2. Weaken a lock-nut of a carving tip of fastening of a cable to the lever of a drive of a butterfly valve (see an accompanying illustration). |
3. Having turned the lever, liberate from it a cable tip. 4. Disconnect a cable from a pedal of gas and turn out two screws of fastening of a cover of hummock assembly to a partition of an impellent compartment. 5. Involve a cable in an impellent compartment. |
|
Installation and adjustment
|
1. Installation is made upside-down, track reliability of landing in an opening in a partition of the rubber plug through passage. 2. Squeeze out against the stop a pedal of gas and make sure of completeness of opening of a butterfly valve. 3. If the zaslonka opens not up to the end, weaken lock-nuts, squeeze out a pedal and make the corresponding adjustment of a cable. 4. Tighten lock-nuts, make sure that at a pedal otpuskaniye the zaslonka is completely closed. |
|
|
|