Toyota Land Cruiser, Amazon, LX470 Lexus + Identification numbers of the car + Governing bodies and receptions of safe operation of the car + Settings and routine maintenance of the car + Engine + Systems of cooling of the engine, salon and air conditioning heating - Power supply system and production of the fulfilled gases Specifications Sbrasyvaniye of pressure in a power supply system Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel Check of a condition and replacement of fuel lines and their shtutserny connections Removal and installation of a fuel tank Cleaning and repair of a fuel tank - general information Removal and installation of the fuel pump Replacement of the sensor of fuel consumption Removal and installation of assembly of an air purifier Removal, installation and adjustment of a cable of an accelerator System of electronic injection of fuel (EFI) - the general information Check of serviceability of functioning of system of electronic injection Check of a condition and replacement of components of system of injection Release system - the general information Removal and installation of nozzles + engine Electric equipment + Control systems of the engine and decrease in toxicity of the fulfilled gases + gear shifting Box + Transmission line + Brake system + Suspension bracket and steering + Body + Onboard electric equipment
|
Release system – the general information
|
It is necessary to start service of system of release only after complete cooling of its components, remember that the surface of the catalytic converter in use the car can heat up to very high temperatures! Track reliability of fixing of the car in the lifted situation.
|
Typical design of system of production of the fulfilled gases
Replacement of components of system of production of the fulfilled gases consists mainly in dismantle and installation a thermoprotective screens/detachment and connection of sections of assembly (address to an illustration above). It is necessary to remember that thermofilters and rubber подвесы basic arms should be established at assembly strictly on the former places. In view of that in use the car components of system of production of the fulfilled gases constantly are exposed to aggressive influences of environment and high temperatures, components of assembly can appear «tightly become attached» to each other therefore, before starting a fixture otpuskaniye, it is necessary to impregnate joints of the corresponding sections with getting oil. In especially hard cases it is necessary to use a hacksaw, a chisel or autogenous cutting.
|
|