Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation

Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
- Power supply system and production of the fulfilled gases
   Sbrasyvaniye of pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a condition and replacement of fuel lines and their shtutserny connections
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Removal and installation of the fuel pump
   Replacement of the sensor of fuel consumption
   Removal and installation of assembly of an air purifier
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of electronic injection
   Check of a condition and replacement of components of system of injection
   Release system - the general information
   Removal and installation of nozzles
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of a fuel tank

See preventions at the beginning of pressure Sbrasyvaniye's Section in a power supply system.

Details of installation of a fuel tank


1. For the purpose of dumping of superfluous pressure in a tank uncover a jellied mouth.
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

3. To Poddomkratta the car also establish it on props.
4. Turn out a drain stopper and lower fuel in the prepared capacity of suitable volume (address to an illustration above).
5. Disconnect electroconducting of the fuel pump/sensor of fuel consumption and remove them.
6. Remove the protective pallet of a fuel tank.
7. Disconnect gasoline pipe lines and the line of return of fuel evaporations.

Each of the mentioned lines has unique diameter that guarantees unambiguity of their connection at assembly. In case of doubts mark disconnected components. At once закупорьте open ends of tubes.

8. Turn out fixing screws and disconnect a jellied mouth and a ventilating tube of a fuel tank.
9. Prop up a tank a telezhechny jack, for distribution of loading having laid between a head of the last and a tank bottom wooden whetstone.
10. Release fixture and lower assembly brackets of fastening of a tank then smoothly lower a tank down.
11. Installation is made upside-down. Track, that tubes and hoses were not pressed.