Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
- Power supply system and production of the fulfilled gases
Specifications
Sbrasyvaniye of pressure in a power supply system
Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
Check of a condition and replacement of fuel lines and their shtutserny connections
Removal and installation of a fuel tank
Cleaning and repair of a fuel tank - general information
Removal and installation of the fuel pump
Replacement of the sensor of fuel consumption
Removal and installation of assembly of an air purifier
Removal, installation and adjustment of a cable of an accelerator
System of electronic injection of fuel (EFI) - the general information
Check of serviceability of functioning of system of electronic injection
Check of a condition and replacement of components of system of injection
Release system - the general information
Removal and installation of nozzles
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Sbrasyvaniye of pressure in a power supply system
|
|
Remember that gasoline is extremely inflammable liquid! At work with components of a power supply system observe all taken measures of fire safety. Do not smoke! Do not come nearer to a venue of works with open fire or unprotected by the lamp shade carrying! Do not make system service in the rooms equipped with working at natural gas and heating devices equipped with a control torch (such as водогреи and dryers for clothes). Do not forget that gasoline is among cancerogenic substances, i.e. the substances promoting development of a cancer! Try not to allow fuel hits on open sites of a body, use rubber protective gloves, at casual unforeseen contact to fuel carefully wash out hands warm water with soap. Immediately collect the spilled fuel and do not put the rags impregnated with a fuels and lubricants near sources of open fire. Remember that the power supply system equipped with injection of fuel of models constantly is under pressure. Before starting a detachment of fuel lines, dump residual pressure in system. At service of components of a power supply system put on goggles. Constantly hold near at hand the class B fire extinguisher! |
|
|
1. Pressure dumping in a power supply system should be carried out before service of any of its components for the purpose of minimization of risk of ignition of fuel and receiving by the performer of traumas.
2. For dumping of superfluous pressure in a fuel tank uncover a jellied mouth.
3. There are two ways of dumping of pressure in a power supply system: disunite the contact socket of electroconducting of the fuel pump, or take the Relay of Disconnection of the Chain, – estimate what of actions it can be made with smaller expenses of forces and time. The socket of electroconducting of the pump is directly on assembly of a fuel tank (see. Section Removal and installation of the fuel pump).
4. Start the engine and wait its spontaneous останова, then turn the ignition key in the situation OFF.
5. For a guarantee of completeness of a discharge of system turn the engine several times a starter. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action! |
6. When undocking shtutserny connections follows обкладывать their paper towels for collecting spilled fuel. |
|
|
|
