Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
- Transmission line
Specifications
Driveshafts and hinges - the general information
Check of a condition of the transmission line
Removal and driveshaft installation
Replacement of kardanny hinges
Driving shaft/semi-axes, - the general information and condition check
Removal and installation of semi-axes, bearings and epiploons of the back bridge
Replacement of an epiploon of a leading gear wheel of differential
Removal and installation of assembly of the back bridge
Removal and installation of power shafts
Replacement of protective covers and service of CV JOINTS
Removal and installation of assembly of forward differential
Removal and installation of naves with a disconnected drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of assembly of the back bridge
|
|
At the corresponding complete set block differential of the back bridge. |
|
|
1. Weaken nuts of fastening of back wheels. To Poddomkratta the car also establish it on the props got under bearing frame, not under the back bridge). Prop up forward wheels protivootkatny boots. Remove back wheels.
2. Get a jack under a case of differential of assembly of the back bridge.
3. Disconnect the driveshaft from differential (see. The section Removal and driveshaft installation) also tie up it aside to frame elements. Remove semi-axes (see. Section Removal and installation of semi-axes, bearings and epiploons of the back bridge).
4. Disconnect from a bridge case all brake lines fixed on it. At once закупорьте open ends of tubes and hoses.
5. Remove assemblies of back brake mechanisms (see. Head Brake system).
6. Disconnect from brake mechanisms cables of a drive of the parking brake, then liberate cables from clamps on a case of the back bridge (see. Head Brake system).
7. Disconnect from a case of the back bridge and tie up aside a ventilating hose.
8. Remove shock-absorbers from basic arms on a bridge case, compress them and take aside.
9. Disconnect a bar of the stabilizer of cross-section stability, a cross-section jet bar, the top and bottom levers of a suspension bracket (see. Head Suspension bracket and steering).
10. Lower the jack got under differential and take assembly of the back bridge from under the car.
11. Installation is made upside-down. Track, that all fixture of elements of a suspension bracket was tightened with demanded effort (see. Head Suspension bracket and steering).
12. Pump over brake system (see. Head Brake system). |
|
|
|