Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
- Transmission line
Specifications
Driveshafts and hinges - the general information
Check of a condition of the transmission line
Removal and driveshaft installation
Replacement of kardanny hinges
Driving shaft/semi-axes, - the general information and condition check
Removal and installation of semi-axes, bearings and epiploons of the back bridge
Replacement of an epiploon of a leading gear wheel of differential
Removal and installation of assembly of the back bridge
Removal and installation of power shafts
Replacement of protective covers and service of CV JOINTS
Removal and installation of assembly of forward differential
Removal and installation of naves with a disconnected drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of power shafts
Nave of a forward suspension bracket
|
|
1. Weaken wheel nuts, поддомкратьте the car and establish it on props. Remove the corresponding forward wheel.
2. Empty differential (see. Head of Control and routine maintenance of the car).
3. Remove a brake support (see. Head Brake system).
4. Remove a nave (see. The section Removal and installation of naves with a disconnected drive), then take a lock ring and throw off a remote washer (address to an illustration above).
5. Обстучав through a brass drift, weaken shaft landing in assembly of a rotary fist.
6. Disconnect from a rotary fist the bottom lever of a suspension bracket (see. Head Suspension bracket and steering).
7. Take away fist assembly outside and liberate an internal pin of a power shaft from differential assembly, – in case of need обстучите a shaft a hammer with soft brisk for weakening of its landing in a lateral gear wheel.
8. Installation is made upside-down. Track reliability of a tightening of a stupichny nut. |
|
|
|
