Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation


Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
- Transmission line
   Specifications
   Driveshafts and hinges - the general information
   Check of a condition of the transmission line
   Removal and driveshaft installation
   Replacement of kardanny hinges
   Driving shaft/semi-axes, - the general information and condition check
   Removal and installation of semi-axes, bearings and epiploons of the back bridge
   Replacement of an epiploon of a leading gear wheel of differential
   Removal and installation of assembly of the back bridge
   Removal and installation of power shafts
   Replacement of protective covers and service of CV JOINTS
   Removal and installation of assembly of forward differential
   Removal and installation of naves with a disconnected drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of assembly of forward differential

Removal and installation

At the corresponding complete set block differential of the forward bridge.

Details of installation of assembly of forward differential

1 — the Right power shaft
2 — Elektroprovodka of the ADD sensor switch
3 — the Vacuum hose (models with ADD
4 — the Tube
5 — the Branch pipe сапуна
6 — the Forward driveshaft
7 — differential Assembly
8 — the Jellied stopper

9 — the Sealing washer
10 — the Pillow of a back support
11 — the Pillow of the right forward support
12 — the Sealing washer
13 — the Drain stopper
14 — the Lock ring
15 — the Pillow of the left forward support
16 — the Left power shaft


 PERFORMANCE ORDER

1. Weaken wheel nuts, поддомкратьте the car and establish it on props. Remove forward wheels.
2. Remove protection of a case.
3. Merge from differential oil (see. Head of Control and routine maintenance of the car).
4. Disconnect from assembly of forward differential the driveshaft (see. The section Removal and driveshaft installation) also tie up its forward end to elements of a frame of the car. Disconnect a branch pipe сапуна, give a bolt of fastening of a vacuum tube and disconnect assembly of tubes from differential (address to an illustration above).
5. Remove power shafts (see. Section Removal and installation of power shafts).
6. Prop up differential a transmission or telezhechny jack and give fixture of support of differential.
7. Omit assembly of differential and take it from under the car, trying not to scratch interfaced surfaces.
8. Installation is made upside-down.