Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation



Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
- Gear shifting box
   - Automatic transmission (AT)
      AT problem diagnostics - the general information
      Adjustment of draft of gear shifting
      Check, adjustment and replacement of the sensor switch of permission of start
      Removal and installation of assembly of the lever of the AT selector
      Removal and installation of automatic transmission
   + Transfer case
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Check, adjustment and replacement of the sensor switch of permission of start

Check

 PERFORMANCE ORDER

The sensor switch provides possibility of implementation of start of the engine only in two provisions AT: "R" and «N». If the engine is started in any other position of the lever, therefore, the sensor switch of permission of start is faulty, or its adjustment is broken. First of all it is necessary to check serviceability of a condition of the sensor switch. The faulty sensor switch is subject to replacement.

Adjustment

 PERFORMANCE ORDER

1. Transfer the AT selector lever to the situation "N".
2. To Poddomkratta the car also establish it on props.
3. Weaken a bolt of fastening of the sensor switch (address to an accompanying illustration).
4. Achieve combination of an adjusting groove from a base risky neutral (address to an illustration above).
5. Having fixed the sensor switch in the chosen situation, tighten a fixing bolt with demanded effort.

Replacement

 PERFORMANCE ORDER

1. If disturbs, remove a reception pipe of system of production of the fulfilled gases and the thermofilter (see. Head of the Power supply system and production of the fulfilled gases).
2. Release collars and disconnect tubes of a maslookhladitel.
3. Disconnect electroconducting from the sensor switch of permission of start.
4. Unbend a lock washer and give a fixing nut.
5. Turn out a bolt of fastening of the sensor switch (address to an illustration above).
6. Remove the sensor switch.
7. Installation is made upside-down. Tighten fixture with demanded effort. Do not forget to make adjustment of the sensor switch and to make sure of serviceability of its functioning.