Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation



Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
- Gear shifting box
   - Automatic transmission (AT)
      AT problem diagnostics - the general information
      Adjustment of draft of gear shifting
      Check, adjustment and replacement of the sensor switch of permission of start
      Removal and installation of assembly of the lever of the AT selector
      Removal and installation of automatic transmission
   + Transfer case
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Adjustment of draft of gear shifting

 PERFORMANCE ORDER

1. Check freedom of moving of the executive lever when translating draft of switching from the situation "R" in all other provisions of transmission, – if the indication of the indicator of the selector does not coincide with actually chosen situation, it is necessary to make adjustment of driving draft.
2. To Poddomkratta the car also establish it on props.
3. Weaken a nut of fastening of draft of switching to the selector lever (address to an accompanying illustration).
4. Wring out the manual lever on transmission (the small lever connecting draft of switching to manual shaft in transmission) to the right against the stop, then return it on two clicks back, having transferred that to AT neutral situation.
5. Transfer the selector lever in car salon to the situation "N".
6. Ask the assistant to fix the selector lever in the situation "N" and from below tighten with demanded effort a nut of fastening of draft of switching to it.
7. Make adjustment of the sensor switch of permission of start (see. Section Check, adjustment and replacement of the sensor switch of permission of start).
8. Make sure of correctness of adjustment: the lever of the selector should freely is transferred to each of provided by a design of the device of provisions, thus start of the engine should become possible only in the positions "R" and "N" of the lever. In case of need repeat adjustment, achieving performance of all listed above conditions.