Repair and Toyota Land Cruiser 100/Amazon, Lexus LX 470 car operation - Check of pressure of oil//Toyota Land Cruiser, Amazon, LX470 Lexus / avto2tyning.ru

Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation



Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
- Engine
   - Typical procedures of service of engines
      Preparatory actions and the list of repair procedures which can be executed without engine extraction from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
      Check of pressure of oil
      Check of kompressionny pressure in cylinders
   + Procedures of service of the petrol engine
   + Procedures of service of the diesel engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Check of pressure of oil

Pressure drop of oil can be considered as a sign of that the engine needs regenerative repair. The control lamp of pressure of oil is not among the diagnostic equipment supervising a condition of system of greasing, and only informs the driver on dangerous decrease in oil pressure. Even the measuring instrument of pressure of oil built in the dashboard, despite a big detail of issued information, it is possible to consider only as the device of information character. For data acquisition about pressure of oil which then can be compared to requirements of Specifications, it is necessary to use mechanical (not the electric!) a manometer complete with an exact tachometer.

 PERFORMANCE ORDER

1. Find the block of the sensor switch of pressure of oil.
2. Remove the sensor switch and establish instead of it a transitional nozzle for connection of a mechanical manometer. For sealing of carving connection of a nozzle use a sealing tape from teflon, or a tape FUM.
3. According to instructions of manufacturers connect to the engine an exact tachometer.
4. Check pressure of oil at working on the turns stipulated in Specifications the heated-up engine to normal working temperature. Compare results of measurements to standard requirements. At excessively low pressure it is necessary to estimate degree of wear of bearings and/or the oil pump.








Sural Saray Hotel, ски в московской области