Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation

Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
- Gear shifting box
   + Automatic transmission (AT)
   - Transfer case
      Removal and installation of a transfer case
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of a transfer case

Details of installation of a transfer case


1. To Poddomkratta the car also establish it on props.
2. Give 3 bolts of fastening of a protective casing of a transfer case and remove it.
3. Merge oil from a transfer case.
4. Remove forward and back driveshafts (see. Head Transmission line).
5. Disconnect knot of draft of a drive of management of a transfer case (address to an illustration above).
6. Remove a clamp, a washer, a wavy washer and the plug and disconnect knot of shifting draft.
7. Turn out a bolt of the tire "weights" and remove it.
8. Prop up transmission by a rack.

Not to damage the pallet, lay a piece of a board.

9. Give 8 bolts, 2 nuts and remove a cross-section beam.
10. Disconnect a ventilation hose, having remembered the provision of a clamp.
11. Disconnect the socket of the VSS No. 1, 3 sensor of the socket of sensors indicators of a mode of a transfer case and the socket of the electromotor of the actuation mechanism.
12. Slightly raise a transfer case and substitute under it a transmission rack.
13. Unfasten from a transfer case conducting.
14. Unscrew 6 bolts of fastening of the adapter of a box and remove a transfer case down and back.
15. Installation is made upside-down. Track, that all fixture was tightened according to requirements shown in Specifications.