Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation

Removal and installation of door glasses

In order to avoid receiving cuts of hands about edges of technological openings in a doorframe work in gloves!

PERFORMANCE ORDER

Lower glass in extreme bottom situation. On the models equipped with electrodriving window regulators / the uniform lock, disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

Forward doors

PERFORMANCE ORDER

1. Remove a door rear-view mirror (see. Section Removal and installation of external rear-view mirrors).
2. Remove the panel of an internal upholstery of a door and the vlagozashchitny screen (see. Section Removal and installation of panels of an internal upholstery of doors).
3. Remove internal and external sealing tapes (address to an illustration the Forward door and its components).
4. Unscrew two bolts of fastening of a directing trench of glass and take out glass from a door outside and up. Having hooked a trench, accurately remove it.
5. Installation is made upside-down. Track reliability of a zashchelkivaniye and a fixture tightening.

Back doors

Design of assembly of a back door

1 — Models with the uniform lock
2 — the Door lock
3 — the Fixed back window leaf with a facing sealing tape
4 — Glass
5 — the External sealing tape
6 — the Directing tape of facing of a window aperture
7 — the Dividing level
8 — the External handle
9 — the Button of switching off of the lock
10 — the Loop
11 — the Door lock
12 — the Internal sealing tape

13 — the Limiter of opening of a door
14 — a window regulator Regulator
15 — the Cover of a service opening
16 — the Internal handle
17 — the Armrest
18 — the Switch of management of functioning of the electric drive of a window regulator
19 — the Panel of an internal upholstery
20 — Models without the electric drive of window regulators
21 — a window regulator Regulator
22 — the Lock ring
23 — the Plug
24 — the regulator Handle

PERFORMANCE ORDER

1. Remove internal and external sealing tapes (address to an illustration above).
2. Remove a dividing level, the back fixed window leaf with a sealing facing tape and directing tape of facing of a window aperture.
3. Remove assembly of a latch of the door lock with the external handle (see. Section Removal and installation of latches, zamkovy cylinders and door handles).
4. Remove a window regulator regulator (see. Section Removal and installation of regulators of window regulators).
5. Remove door glass.
6. Installation is made upside-down.