Toyota Land Cruiser 100/Amazon, Lexus LX 470

since 1997 of release

Repair and car operation


Toyota Land Cruiser, Amazon, LX470 Lexus
+ Identification numbers of the car
+ Governing bodies and receptions of safe operation of the car
+ Settings and routine maintenance of the car
+ Engine
+ Systems of cooling of the engine, salon and air conditioning heating
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Control systems of the engine and decrease in toxicity of the fulfilled gases
+ gear shifting Box
- Transmission line
   Specifications
   Driveshafts and hinges - the general information
   Check of a condition of the transmission line
   Removal and driveshaft installation
   Replacement of kardanny hinges
   Driving shaft/semi-axes, - the general information and condition check
   Removal and installation of semi-axes, bearings and epiploons of the back bridge
   Replacement of an epiploon of a leading gear wheel of differential
   Removal and installation of assembly of the back bridge
   Removal and installation of power shafts
   Replacement of protective covers and service of CV JOINTS
   Removal and installation of assembly of forward differential
   Removal and installation of naves with a disconnected drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Порно видео hd. Porn - http://porno-mp4.net/. Порнуха онлайн.

Removal and installation of semi-axes, bearings and epiploons of the back bridge

Details of installation of a back semi-axis and nave


 PERFORMANCE ORDER

1. Release the parking brake. To Poddomkratta a car back also establish it on props. Prop up forward wheels protivootkatny boots. Details of installation of a semi-axis are presented on an illustration above.
2. On the equipped ABS models remove the wheel sensor. (See. Head Brake system).
3. Remove assembly of the brake mechanism (see. Head Brake system).
4. Disconnect a cable of a drive of the parking brake and the hydraulic line from the wheel cylinder (see. Head Brake system).
5. Give four nuts of fastening of a back plate of a semi-axis to a case of the back bridge.
6. Take a semi-axis from a bridge case, try not to damage an epiploon.
7. Take from the flute in a face surface of a case a sealing ring.
8. Having hooked a big screw-driver, or having used the special tool, take a semi-axis epiploon (address to an accompanying illustration).
9. Further dismantling of the back bridge demands use of special tools, including a hydraulic press and should be charged to specialists of car-care center.
10. Having used as an opravka a face head of the suitable size or a piece of a pipe of the corresponding diameter, plant in a bridge case a new epiploon of a semi-axis, grease epiploon sponges with universal greasing.
11. Having slightly oiled, establish a new sealing ring.
12. Estimate a condition of a surface of a semi-axis, remove teases and the agnails, capable to bring to epiploon damage. Slightly grease a semi-axis with pure oil and fill it in a bridge case, try not to damage shlitsa an epiploon.
13. Further installation is made as it should be the return to an order of dismantle of components. Track, that nuts of fastening of a face plate were tightened with demanded effort.